H-Priv Pro

H-PRIV PRO

ASTONISHING PERFORMANCE

H-Priv Pro Kit consists of H-Priv 220 mod and TFV8 Big Baby tank. Simple and hard lines make the kit 

looks very fashionable; it delivers a satisfying amount of vapor at 220W maximum output and comes 

with adjustable airflow system of TFV8 Big Baby tank, for different vaping experiences. Big fire key 

brings you astonishing experience.

H-PRIV PRO




WHERE IS THE FIRE KEY?

This is an innovative design! The fire key of H-Priv combines the inconspicuous fire key with the mod 

well. Then your friends will ask that: “Where is the fire key?”


220W POWER FOR VAPING!

H-Priv mod has the largest output power of SMOK brand. It compatibles with all atomizers and RTA 

series atomizers, you can enjoy vaping freely by it!


OUTSTANDING 

PERFORMANCE & COLORFUL 

FINISH OPTIONS

In addition to its portability and compact size, H-Priv has a fundamentally improvement in finish. The 

new paint finish adds a shiny look and soft feel, and is more durable than an oxidized one. What’s 

more, it provides more eye catching colors for you to choose.


NEW BATTERY COVER DESIGN

H-Priv battery cover uses injection molding, and designed with 8 venting holes and magnet holding 

features to make battery replacement easier. The 24k gold plated positive and negative terminals has 

high electrical conductivity. Along with visible & clear battery installation indication and insulation 

layer protection, H-Priv is safer to vape.


SLOT DESIGN BATTERY COVER


MORE CONVENIENT AND 

SAFER


STRUCTURE DESIGN



STRUCTURE DESIGN


DELRIN DRIP TIP

The delrin drip tip will bring increased airflow and provide you with powerful draw effects.


ADJUSTABLE AIRFLOW 

SYSTEM

Bring you an extremely open draw. Airflow can be adjusted freely by turning the ring at the base of 

tank.


V8 BABY CORE

TOP REFILL SYSTEM

Top refill system makes filling as easy as it gets. Leak proof e-liquid slot can significantly solve leaking 

problem.


HOW TO BUILD THE RBA

1 . Before starting make sure your hands 

2. Taking RBA deck apart.


3. Installing and positioning the pre-wrapped coil. Place the coil between the posts and wrap the ends 

around the screws and tighten up, once all in place make sure the coil is fixed in the center and lined 


up with the air hole, and also make sure the coil is NOT touching the base. 
4. Cutting the ends of wire off.



5. Cutting a strip of cotton and make sure it’s not too much and not too less.
6. Inserting the cotton, and placing it in the middle.
7. Cutting the cotton at an angle and make sure it’s not too short and not too long.




8. Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked 


periodically toensure the resistance remains the same.


WARNING
You have to make sure that your age is 18 or older, then you can browse this website further. Otherwise, please leave and close this page immediately !