Air flow controller Pod use skills

1、Clean the pod and mod connection part method.

Regularly use a dry cotton swab or a slightly moistened cotton swab to clean the connection points between the Mod and the POD base, clean the mositure.

If there is too much mositure remaining, it may block the airflow holes and make it impossible to vape.

2、What are the steps to use pod to vape?

When a new coil is installed, let it sit for 3 minutes after filled with e-liquid before vaping.The first few puffs require a bit harder inhale, then you only need to vape normally.

3、How to use the rubber plug.

After filling pod with e-liquid, make sure the rubber plug is installed correctly. If there is warp, make sure it's flattened to avoid leaking.

4、What is the best way to store POD without using them for a short time? 

It is best to fully charge the mod and take out the cartridge to avoid e-liquid  leakage and Keep out of reach of children.


WARNING
This product is intended to be used with e-liquid products containing nicotine. Nicotine is an addictive chemical.
Important Safety Information and Warnings
You have to make sure that your age is 21 or older, then you can browse this website further. Otherwise, please leave and close this page immediately!