NuMicro ISP Programming Tool for Osub Plus(Not for Osub mini/Osub 40w/Osub King)

UPGRADE TOOL FOR YOUR OSUB PLUS

OSUB PLUS V1.1.7

1.   Vaping is more comfortable with more accurate Temperature Control

PREPARATION

1. Factory Micro USB cable (with data transfer function).

2. OS System requirement: Windows XP/7/8/10. (FYI: There is no driver to match Apple Mac OS from the PCB chip vendor.)


DOWNLOAD LINK

Osub Plus upgrade tool&firmware (v1.1.7)(zip)


Guideline

1.    Open the Osub Plus upgrading Tool folder with the programming tool and BIN file, and then

open the ISP tool in the arrow


2.  Connect your Osub Plus to the computer


3.   Give the fire button 3 times to enter in menus, and then find out the “Setting”


4.   After entering into “Setting”, choose the “Download” icon


5.   Turn the “Download” mode on, and then keep holding the fire button to do the following upgrade steps


6.    Click the “Connect” icon till the “disconnect ” icon come with light


7.    Click “APROM” icon


8.  Find out the BIN file in the arrow of the folder and open it


9.    Please mind that the “Config” data should be 00013000. Redownload the ISP tool if you can’t adjust it


10.   Mark “APROM” file icon, then click "Start"


11.   Please mention that you will get a PASS if you have upgraded your Osub Plus successfully.


WARNING
You have to make sure that your age is 21 or older, then you can browse this website further. Otherwise, please leave and close this page immediately !