Error on reading resistance

Your mod can't read the resistance correctly, show "ohms too low" or "ohms too high",it may caused by these points:

1.There's breakdown for the resistance detection component

2.tank screws are not tight down to the mod

3.Loose contact for the tank or mod

Suggestions & Solutions

1.Identify the problem by switching the tank to other mods and fit the mods with other tanks.

A.if the mod works well with other tanks,it should be the problem of the tanks

B.meanwhile it should be the problems of the mod thread part if the tanks works well with other mods.

2.If it is the mod issue, please try to upgrade it  if there is firmware updating.

3.Please make sure screws are tight on tank, if you use the RBA coil on your mod.

4.Please screw the tank into the mod nice and tight.

This product is intended to be used with e-liquid products containing nicotine. Nicotine is an addictive chemical.
Important Safety Information and Warnings
You have to make sure that your age is 21 or older, then you can browse this website further. Otherwise, please leave and close this page immediately!