WARNING
You have to make sure that your age is 18 or older, then you can browse this website further.
Otherwise, please leave and close this page immediately!
I AM OLDER THAN 18! LEAVE AND CLOSE!

THE KIT INCLUDES

CREATIVE FUNCTIONAL BUTTONS

You can have different vaping experience by the irregular Power button and UP/DOWN button that are filled with creativity.

SCREEN DISPLAY

COMPONENTS

COMPONENTS

DELRIN DRIP TIP

The delrin drip tip will bring increased airflow and provide you with powerful draw effects.

ADJUSTABLE AIRFLOW SYSTEM

Bring you an extremely open draw. Airflow can be adjusted freely by turning the ring at the base of atomizer.

TFV8 BIG BABY BIG FAMILY

TOP REFILL SYSTEM

Top refill system makes filling as easy as it gets.
Leak proof e-liquid slot can significantly solve leaking problem.

HOW TO BUILD THE RBA

1. Before starting, make sure your hands are clean.
2. Take RBA deck apart.

3. Install and position the pre-wrapped coil. Place the coil between the posts and wrap the ends around the screws and tighten up, once all is in place, make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base. 4. Cut the excess ends of the wire off.

5. Cut a strip of cotton and make sure it’s not too much and not too little.
6. Insert the cotton and placing it in the middle of the coil.
7. Cut the cotton at an angle and make sure it’s not too short and not too long.

8. Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.