Micro TFV4 is designed to offer three types of heating cores for different vaping needs: sub-ohm core (0.3Ω Micro CLP2), standard resistance core (1.8Ω Micro MTL) and rebuildable single Clapton core (Micro RCA). Along with two larger replacement glass tubes and two extension adapters, the original 2.5ml tank can be extended to 3.5ml and 5ml so that you can enjoy Micro TFV4 anywhere and anytime. Top refill design makes filling as easy as it gets. Constructed from superior-quality stainless steel and glass, Micro TFV4 will bring you unexpectedly excellent taste! Innovation keeps changing the vaping experience!
MICRO TFV4 BIG FAMILY SUB-OHM SERIES
FLAVOR EDITION SERIES
TEMPERATURE CONTROL SERIES
3.5ML & 5ML CAPACITY EXTENSIONS
This kit includes two larger replacement glass tubes (3.5ml & 5ml)and tank extension adapters so that you can enjoy your Micro TFV4 without having to refill as often.
510 RDA DRIP TIP FOR TOTALLY NEW EXPERIENCE
The 510 RDA drip tip with the V shape airflow channel will definitely create a totally different vaping experience that most people shall like. And its cone-like body looks pretty cool!
ADJUSTABLE AIRFLOW SYSTEM
Bring you an extremely open draw.Airflow can be adjusted freely by either turning the ring on the drip tip or the one at the base of atomizer.
TOP REFILL SYSTEM
Before starting make sure your hands are clean.
Taking the Micro RCA apart.
Micro RCA comes with two build screws on each side, one side is the plus terminal of the deck and the other is minus terminal. This provides more possibility for you to install your coil exactly and comfortably.
The kit includes a small airflow tip that can be placed onto the central airhole of the Rebuildable Clapton Atomizer deck. It is designed for throat hit vape by reducing the airflow.
Installing the pre-wrapped coil.
Place the coil (it can be Clapton coil or others) between the screws and wrap the ends around them and tighten up. Attention: The coil has to be wrapped with one end at the plus terminal, with the other end at the minus terminal.
Positioning and cutting the exceeding ends of wire off.
Make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base.
Then cut the exceeding ends of wire off.
Cutting a strip of cotton and make sure it's not too much and not too less.
Inserting the cotton, and placing it in the middle.
Cutting the cotton at an angle and make sure it's not too short and not too long.
Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.